Download Full DatasheetPDF Datasheet

EN9 Carbon Steel

EN9 steel stockholders and suppliers. EN9 is a medium carbon steel grade available as full bar lengths or cut pieces in flat and round bar with delivery to the whole of the UK. It is commonly supplied in the as rolled condition. It can be flame or induction hardened to produce a high surface hardness with excellent wear resistance for a carbon steel grade. EN9 bar is available in full lengths or can be cut to your requirements. EN9 flame cut steel plates can be supplied cut to your required sizes and normalized. Flame cut plates can be supplied Lumsden ground or precision ground.

EN9 steel is held on stock and can be delivered throughout the UK.  All orders are supplied in accordance with our ISO 9001 accreditation.

Alternative carbon steel grades we supply  EN3 | EN8 | EN32 |  EN43|  070M20 | 080M40 | 070M55 | 080A15 | S275 | S355  |  Key Steel | C45

Form of Supply

West Yorkshire Steel are steel stockholders and suppliers of EN9 carbon steel in round, square, hexagon and flat bar. Diameters and flat bar can be sawn cut to your exact requirements. West Yorkshire Steel can offer flame cut profile plates in grade EN9, which can be surface ground if required. Ground steel bar can be supplied, providing a precision ground steel bar to tight tolerances.

Click here to contact our experienced sales team who will assist you with your enquiry.

  • Sheet
  • Plate
  • Flat
  • Diameter
  • Hexagonal

Click on the headings below for further information

Applications

EN9 is used commonly for many general engineering applications. Typical applications include, shafts, axes, knives, bushes, crankshafts, screws, sickles, wood working drills and hammers.

Carbon 0.50-0.60% Phosphorous 0.06% max
Manganese 0.50-0.80% Sulphur 0.06% max
Silicon 0.05-0.35%

West Yorkshire Steel are suppliers of EN9 flame cut steel profiles. A hard edge can occur when flame cutting EN9 plates therefore this grade is commonly normalised after cutting. EN9 flame cut profiles can be supplied Lumsden ground or precision ground.

Precision ground flat stock / gauge plate can be produced using EN9 steel. Subject to size suitability and availability of raw material pieces can be produced in approximately 2 to 3 weeks. Standard and non-standard sizes are available.

Preheat the steel carefully, then raise the temperature to 1100°C for forging. Do not forge below 850°C. After forging cool slowly, preferably in a furnace.

Heat the steel slowly to 680-710°C, soak well. Cool slowly in the furnace.

Heat slowly to 820-840°C and allow it to be heated through. Quench in oil, brine or water.

Temper the EN9 steel component immediately after quenching whilst still hand warm. Re-heat to the tempering temperature then soak for one hour per 25 millimetre of total thickness (2 hours minimum) Cool in air. For most applications tempering of EN9 will be between 550-660°C.

We recommend you contact your welding consumables supplier who should provide you full assistance and information on welding EN9 steel.

Heat treatment temperatures, including rate of heating, cooling and soaking times will vary due to factors such as the shape and size of each EN9 steel component. Other considerations during the heat treatment process include the type of furnace, quenching medium and work piece transfer facilities. Please consult your heat treatment provider for full guidance on heat treatment of EN9 carbon steel.

EN9 carbon steel is available with a cast and analysis certificate or a BS EN 10204 3.1 mill certificate, please request when placing any orders.

EN9 is supplied in accordance with our ISO 9001:2015 registration.

UK Delivery UK Delivery only £35.00
ISO 9001:2015 Registration